I used a little bottle of nose to reduce this gunk that had wrapped up the spin. When the rubber belt is disconnected from the engine the machine will fall down and uncover an area directly below the belt to the ground on the dryer. To explain previous instructions add the following step after step 3. Then pour the water use a funnel or tube into the chamber where the condensate evaporates it should flow into the tank at the bottom of the machine. There are two sets of wire running into the top of the pump one red one pink. It is not clear that there is a tank especially if it is built on a diust over it. Screw two torques holding the lid on the tank. wiring by releasing the Phoenix connectors. I was not offered to rewind the dryer because I started pouring plenty of water about 2 liters each time in the room where the condensation tank ran in. I have repeatedly cleaned the condensate filter according to user instructions and even used to drink the filter in vinegar overnight but this has not made a difference. There are two holes in the main bowl of the pump and inside it can be seen whether there is a structure of tape or hair.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |